Injector Opinion on a Camm'd, Forged 4e + VF23 Turbo

[Rosco]

Looking for opinions on which injectors to run on the below spec. I had 440cc injectors in mind but not wanting to limit my options.

Looking to run 1 BAR max on a VF23 turbo but with std management, upgraded fuel pump, RRFPR and an SAFC plus the following:

Wisco Low Compression Pistons 74.5mm
Scat H-Beam Forged Conrods
ACL Bottom End Race Bearing Kit
Block Professionally Rebored and Honed
ZEP 1.2mm Head Gasket
Ported and Polished Head
Heavy Duty Valve Springs
265deg Billet Cams with 8mm Lift
wepr manifold
ricky-lee decat pipe
zigen5 exhaust
external wastegate
screamer pipe

 

[MentaLEP91]

550cc or 440cc are more suitable for this application, what im not sure about is the use of SAFC in a forged engine. Why not get an Emanage blue or something similar which will perform better?

 

[Sheldon]

that spec list and an safc... and why 1 bar? i guess cos of the managment? im not sure how well will it run with bigger injectors and safc

 

[Chris@CCM]

y would u spend all that money and piss it up the wall cos of a crap ecu or no ecu get ur self a pfc or somthing and the car will drive so much better ps acl dont make race bearing kits for 4es

 

[Rosco]

I'm only going by what I've been told the spec is so will dig a little deeper into that Chris.

The SAFC was purely as a temp measure until I get a powerfc as I already had one laying about going spare. Thinking I might just wait and get all the remaining bits in one go and run 1.5ish BAR instead.

I'm only running 12psi the now and it fair shifts, quite laggy though lol

 

[Skalabala]

7MGTE injectors