little problem

[widdo]

i have just fitted a hks actuator and fcd, its set at 1.0bar. but when i set off normal, then floor it, it doesnt feel like it is pulling right till it gets to about 5000rpm. like its trying to pull but cant. everything else on car is standard.

help?

cheers

 

[Wild]

FCD set up right?

 

[widdo]

fuck nos i dont no how to, i posted askin how but got no reply lol

 

[thefalls]

Do you have a boost gauge?
better check what boost ur running and at what rpm.

 

[widdo]

rrfpr and safc?? what are they mate?

 

[Jay]

I sure hope you know this but..

Fuelcut is a safety device to prevent your car overboosting and subsequently running lean.

Removing it will allow your engine to boost past this 'safe guard'.

To protect your engine you need to ensure the adequate fuelling can be supplied BEFORE fitting a FCD or similar device.

Otherwise the health of your pistons and rings may be at risk..

 

[widdo]

oh ryt cheers

so what do i need asap then?

 

[Chris@CCM]

oh ryt cheers

so what do i need asap then?

rrfpr and a fuel pump would be good too

 

[widdo]

ryt i will get them asda then, how much we looking at?

cheers (god u buy one thing and it never ends haha)

 

[Jay]

Turn your boost down mate. Before you do damage.

What is the car boosting at the minute according to your boost gauge?

 

[widdo]

its boosting 1.0 bar. i will turn it ryt down for tym being then

will a FSE Fuel Pressure Regulator do the job? also the fuel pump?

 

[Adam_Glanza]

yea mate dont drive the car until you get it sorted or itll detonate and blow up and you defo dont want that, get yourself a fuel regulator and a fuel pump and then youll be safe to go for 1 bar

 

[widdo]

ok cheers

http://toyotagtturbo.com/showthread.php?t=2058

will that fpr be ok mate?