tjwilson-glanza V
Fresh Recruit
Hey everyone,
Just finished round the garage after fitting my new Zisco manifold/downpipe, and relocating my air filter to behind the bumber...
Everything looked and went smooth apart from a small blow from the downpipe to centre section, due to not having a gasket so that will be tomorrow. Then went for a test drive and noticed it was only boosting to 0.5... I ported the wastegate slightly to compensate much more air going in to help stop boost creep (this had a small crack, quite minute). and fitted all new gaskets. I still have original actuator, bypass solenoid and removed the low boost.
Does anyone know why im only boosting to 0.5?
Tobie
Just finished round the garage after fitting my new Zisco manifold/downpipe, and relocating my air filter to behind the bumber...
Everything looked and went smooth apart from a small blow from the downpipe to centre section, due to not having a gasket so that will be tomorrow. Then went for a test drive and noticed it was only boosting to 0.5... I ported the wastegate slightly to compensate much more air going in to help stop boost creep (this had a small crack, quite minute). and fitted all new gaskets. I still have original actuator, bypass solenoid and removed the low boost.
Does anyone know why im only boosting to 0.5?
Tobie