****mega clutch judder, help*****

[turboflow]

I changed my gearbox a few months back and put on a new clutch and it has been fine apart from a small judder in first on pull awaywhich is the clutch judder but today i goot home and something has started scraping on the bell housing shield when the clutch goes down so i bent it away from the gear and it stopped but when i went to pull away off my drive and the thiong damn near jumped off the floor the judder was so bad, but once bitten i can hoof it and its fine and it only does it when i pull away turning right waaaaaaaaaa, some one please help.

cheers
mega rep availiable lol

 

[spuddy]

Wot clutch did u put in?

 

[Shooting Starlet]

standard one spuddy, owen we will have to take it out tonight but sounds like something has come off or broken lets wait and see matey

 

[turboflow]

ahhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhh, paul i am going to get the jeep so i can drive that will give u a call when i am back, help would still be appreciated. i have made a monumental fuck up some where and i hope so have one of you before, i mean that in the nicest possible way ofcourse

 

[Shooting Starlet]

not with my car matey ......as you see my clutch has been in 6months and no probs nerrrr nerrrr

 

[dantheman]

you tighten the pressure plate bolts up properly and evenly?

 

[turboflow]

pass, lol, they were even and im sure i would have got torqe setting but its a possiblility i didnt

 

[dantheman]

not alot in there mate too come loose other than bolts, clutch release bearing and bearing clip/retainer.. either way ganna have to drop the box to find out

 

[turboflow]

yeah its comin off 2night