Well lads i can get my hands on a mega squirt ecu a mate has there, it was in an ae86 am just wondering is there any extras i will need to get this running on my gt, thanks.
Yeah thats one thing i no i will need is the 4 pin variable tps, i can solder fine, but am not sure if will need to add any thing, well its the sort of thing i can pay for when its in and running, mates are great also.
i am running ms2 v3 on a 4efte and are running a 3 pin tps no probs and as far as adding things it depends what you want to do like what ignition control u want launch control ? boost control ? nos ? all need different mods
If it was running in an ae86, then it will run with the 4e, just be sure it has the 2.5bar map sensor. Ignition, injectors, triggers should be the same more or less.
have this mega squirt here its a ms2 v3.57, i see inside it has a wired jumper set up for Direct Coil Control Distributorless Ignition, what way should i go about it i would like to use edis.
0k from what i see its 2 jumper wires needs soldered to activate edis on the v3.57, can leave the jumper wire in for the direct coil or should i take it out,
Never mind the above am not very keen on that setup, so am going to order an extra vr sensor along with a stimulator, am using the stock setup to keep it tidy.
The above link will work no problem for the 4e, all u have to do is to add a 2nd vr circuit to the megasquirt to pick up the 2nd vr signal thats needed, megasquirt 3 ms3x comes with the 2nd vr sensor built in so no mods required there.