Miss fire :(

[02emichan]

Right since I have done a forged build I have a misfire . Well after it had been run in I went and had it mapped and could only go to 1bar due to misfiring and was told it was a spark mis fire .

Since then I have replace the cap arm leads plugs coil amplifier but still misfires

I think it's down to the mapp but can't be sure could anyone help ??

Cheers mike

 

[weeJohn]

Mods list would help mate.

 

[02emichan]

Ok its a 4e forged engine
Emanage ultimate
E-01 boost controller
Ihi vf 22 turbo
550 injectors
Magnacore leads
Heat range 7 plugs with 0.7 gap
Front mount intercooler

Let me no for more info

Cheers mike

 

[weeJohn]

Seen a few problems with the Emanage and boost before. Best advice I could give would be to contact Chris Carson about it, Facebook would be the fastest.

 

[02emichan]

Yh been reading up about this but looking at the graphs with the map at the afr it's a spark misfire and I didn't think that the e manage coud alter that ? But tbh I'm not rili to clued up a bout how they work

 

[wildchild]

check your injectors. also check ur MAP. if u had replaced the ignition coil, leads, plugs and distributor cap then you have to narrow it down to the two of that.
why dont u swap a distributor from a working one just to check. there are two small coil units inside the distributor which would be faulty. just check to make sure.