need help with my power getter...

[adam ep]

basicly i bought my power getter slightly damaged and im asking for help from fellow owners out there....

i am looking for a new front section from decat to the start of the exhaust, be it someone here has one or zisco or somebody could copy me one... or if someone was willing to give me a loan of theres to get it copied.. this is the part highlighted in red that i need. or if anyone has blue print of dimensions of a power getter i will even pay to have a copy.

as you can see my exhaust part highlighted in orange is the wrong shape and has been altered for a diff downpipe

my exhaust middle section was also badly damaged highlighted in yellow and will not sit on my car right so im looking for anyone the check the angle of the bend so i can check mine is correct or if anyone has this section lying around..

the turn on the back box pipe was also damaged and im wondering can anyone measure the angle on theirs to see if mine is correct

..........anyone who helps me out i will be greatful and if they want something in return i shall do that..

can anyone here buy directly off fujitsubo because id be interested in buying new parts?

i hope some exhaust fabricaters on here may have a fujitsubo of their own or can get a loan of one and can make me the front section..

adam

 

[Mark-ep91]

your best bet would be to fit bring the exhaust to a exhaust fabricators or a garage who welds on exhausts and ask them to fit it and add in a bit of pipe if your missing some they can also heat the angle of the exhaust and bend it into shape

 

[corofin12345]

your best bet would be to fit bring the exhaust to a exhaust fabricators or a garage who welds on exhausts and ask them to fit it and add in a bit of pipe if your missing some they can also heat the angle of the exhaust and bend it into shape

x2 and as said on toc-irl

 

[adam ep]

your best bet would be to fit bring the exhaust to a exhaust fabricators or a garage who welds on exhausts and ask them to fit it and add in a bit of pipe if your missing some they can also heat the angle of the exhaust and bend it into shape

yeah actually neva taut of the heating part to bend it back into shape... ......thanks lads

 

[Starletto_Joz]

You'll also be wanting someplace that does mandrel bending (full diameter), none of that pipe bent nonsense.

Hope you get it back to its former glory.

Joz

 

[adam ep]

You'll also be wanting someplace that does mandrel bending (full diameter), none of that pipe bent nonsense.

Hope you get it back to its former glory.

Joz

thanks buddy ya i no a place where theye do mandrell bending, they specialise in A bars for front of jeeps and lorrys etc..