About the relocation radiator kid I couldn’t find anything available. It’s a good idea to keep the temperature low but definitely not just to attach a few sensors. If you have a link let me know because I would buy the relocation kit for that purpose. Thanks
https://www.ebay.co.uk/itm/OIL-TEMP...p2349624.m46890.l6249&mkrid=710-127635-2958-0
The one James posted, I have ones of those laying here to go on the glanza ones the turbo is off(for oil pressure).
The relocation bracket is with regards to the standard 4efte unit which is used to move the oil filter to a different position. Specifically the blanked port on the side of the oil filter housing(James also mentioned this). But I'm not sure yet if the oem blanking plug inside the port is shorter than the m16 adapter bolt, if this blanking plug is shorter the oil flow could potentially be hindered to some degree.
If an relocation kit is already installed to move the pressure sensor for an oil pressure gauge, this should be visible on the gauge. Can also check the hole in the relocation bracket(marked with red square).
I'll get into contact with one of the Dutch people running the relocation bracket, get one myself and test it. Ones I confirmed fitment I'll get back to you. (this is for the d1 spec one)
The greddy unit which supposedly doesn't require any shaving: