OMEX launch control wiring

[corollaman]

Hey guyz i bought this staff and i want to install it . I have power fc running on my engine. In which pins should i plug OMEX i have ep82 ecu (2plugs). Please anyone know reply.


take care

 

[corollaman]

anyone???Please ASAP

 

[Sparky]

http://www.omextechnology.co.uk/Revlimiters/Downloads/RLCLC.PDF

 

[corollaman]

the red wire = coil positive and the blue wire = coil negative which pin are in the ecu wire? or what will the pin say ? because i couldnt find something simillar to these..

please inform me asap

 

[Sparky]

Dont think it needs to go off the ECU.... Just needs an earth and the two wires you mentioned above

 

[corollaman]

i see... and where is the negative and possitive coil? is somewhere in the ignition where the center spark plug goes?

 

[nexia201]

so does this omex run just from the coil? if so i want one ! how much did you get it for mate?

 

[corollaman]

yes i think and this is the main difference from bee r..i bought it for 110 gbp..

 

[corollaman]

bump

 

[corollaman]

i see... and where is the negative and possitive coil? is somewhere in the ignition where the center spark plug goes?

??

 

[Gtstu]

the wires that come off the coil pack go back to the ecu. if it works like a bee r it will be pin 7 and 22 iirc

 

[corollaman]

the 7th pin is ignition feedback from ignitor coil and the 22th sensor ground which will be the negative one and which will be the positive one.

 

[Gtstu]

maybe 23 24 then?

 

[corollaman]

23, 24 are knock sensor and computer grounds...

 

[lowresolution]

Sorry for bumping up on such an old thread ...

But what sort of setup is recommended for the 4efte ? the single coil or the twin coil ?