ChrisW
Lifer
Basically I want to take out an Emanage blue from my EP82 that has the ignition and injector harnesses and also the boost pressure harness with 3 bar sensor. It is hard wired into the main loom so no field extention.
I wanted to know if it is easy to do? Is it just a case of cutting the emanage wires out where it has been tapped into the main loom? Or is there more to it than that? I know that when I remove the boost pressure sensor I have to rejoin the stock sensor to the inlet mani with a vacuum hose. Apart from that Im not 2 sure. ANY help would be greatly appreciated (and I add rep
) Thanks
Chris
I wanted to know if it is easy to do? Is it just a case of cutting the emanage wires out where it has been tapped into the main loom? Or is there more to it than that? I know that when I remove the boost pressure sensor I have to rejoin the stock sensor to the inlet mani with a vacuum hose. Apart from that Im not 2 sure. ANY help would be greatly appreciated (and I add rep
) ThanksChris
