Please help

[QuinnEp91]

Iv rebuild my ep91 and I'm left with this washer and don't know where it's to go, it's a tick washer and has slight surface rust on one side as it probly came from somewhere around the outside of the engine as there's no oil on it..

I don't want turn the engine over till I know where this has to go..

So any help is greatfull

Thanks

 

[weeJohn]

Thinking it may be off the drivers side engine mount bolts, what size is the hole in the middle of it?

 

[QuinnEp91]

13mm on the inside.. Iv been scratchin and pullin my hair out all day

 

[weeJohn]

Toyota didnt use 13mm bolts, only 12mm or 14mm, but it is possible a washer could be made 13mm for a little clearance. Whatever its for, its not going to affect the engine running, so I would go ahead and try to fire it up.

 

[davehart]

If I only had that left after tearing the motor apart I'd be happy

As John says, fire the old beast up! not sure where that washer goes though.

 

[QuinnEp91]

Thanks a lot lads for the help

Will fire her up tomorrow and will post my rebuild pictures up

Thanks again

 

[goldenvtr]

could be anywhere lol,

engine mounts, gearbox bolts or suspension stut (hub) would be my first checks