rubber gromet behind inlet manifold...where does it go!?

churcherj

churcherj

Member +
i am going to try and wire up my gauges 2moro and wire the senders through the rubber gromet just behind to the left of the inlet mani, my question is where would the wires end up? is it a dashboard off job to get to them, or can i reach them another way? i could use the gromet behind the battery and wire it up and through the glovebox but i dont think the sender wires are long enough so need a more direct route!
 
D

damussi

Member +
u good with there, it will land u right behind the dashboard just take off the lower panel under tha steering so u can sort out the wiring better thats where i route all the wires for my gauges
 
churcherj

churcherj

Member +
thanks for the reply lads, rep'd! so literally take off the bottom steering panel and i will be able to get to them? my gauges are going to sit on top of the dash so i will need to drill some holes through so i assume the wires will easily reach?
 
J25GTi

J25GTi

Lifer
Yeah youl be fine like that mate!

thanks for the reply lads, rep'd! so literally take off the bottom steering panel and i will be able to get to them? my gauges are going to sit on top of the dash so i will need to drill some holes through so i assume the wires will easily reach?
Click to expand...
 
You must log in or register to reply here.
Top