wee-jo
Member +
looking for some advice on the engine run in process.
I recently rebuilt my forged engine and I was advised to get a base map put on it after 100-200 miles. Is this neccesary? The only concern I have is that the a/f ratio is quite high, the aem gauge reads 14-15 constantly and I'm worried it will do damage to the engine being that rich.
Is there anyway to reduce the richness without getting it mapped or would you recommend mapping asap? The car runs a td04 with walbro fuel pump and a rrfpr.
Any info would be appreciated.
I recently rebuilt my forged engine and I was advised to get a base map put on it after 100-200 miles. Is this neccesary? The only concern I have is that the a/f ratio is quite high, the aem gauge reads 14-15 constantly and I'm worried it will do damage to the engine being that rich.
Is there anyway to reduce the richness without getting it mapped or would you recommend mapping asap? The car runs a td04 with walbro fuel pump and a rrfpr.
Any info would be appreciated.