I wonder if anyone can tell me how to test whether the selenoid on my BLITZ Twin-SBC is working or not?
Here are the simptoms: Controller lights up and can change from low knob to High knob but neither seem to make much difference to the boost pressure.
Since putting on the controller the boost has gone up from about 0.59/0.62 bar (in fifth gear max) now it's more like 0.89 bar and hits fuel cut, which I don't want cos I have no FCD or fuel mods. I was looking to have 0.8 bar high and 0.6 low but the controller doesnt want to know. Is my solenoid knakard? Ill check the electricity flow with a volt metre at the weekend to see if the solenoid is getting current but other than that im stuck..
cheers in advance
ps I have no adjustable actuator so it may be that I suppose (old tierd standard one fitted)
Here are the simptoms: Controller lights up and can change from low knob to High knob but neither seem to make much difference to the boost pressure.
Since putting on the controller the boost has gone up from about 0.59/0.62 bar (in fifth gear max) now it's more like 0.89 bar and hits fuel cut, which I don't want cos I have no FCD or fuel mods. I was looking to have 0.8 bar high and 0.6 low but the controller doesnt want to know. Is my solenoid knakard? Ill check the electricity flow with a volt metre at the weekend to see if the solenoid is getting current but other than that im stuck..
cheers in advance
ps I have no adjustable actuator so it may be that I suppose (old tierd standard one fitted)
