GlanzaV.Tee
Member +
hey guys i've just had a engine just gaskets al redone but pistons was good when built however i have had 3rd piston melt which threw up oil from the breather and also conrod one bearing melted on the crank basically its fubaard but my question is what cause this.
my spec was
Front mout intercooler
mesh on the ct9
running 0.9 bar
hks actuator
hks fcd- set at 8
thats pretty much it but i was only doing 70mph on way home not hard footed but light and it gave in and puffd white smoke running on 3 pistons when i stopd oil all over the place which i knew straight away bottom end but any help into the cause of this would help much appreciated all and thankyou, i will rep all accordingly to everyone that attempts
but my thinking could be fpr not installed and uprated fuel pump
my spec was
Front mout intercooler
mesh on the ct9
running 0.9 bar
hks actuator
hks fcd- set at 8
thats pretty much it but i was only doing 70mph on way home not hard footed but light and it gave in and puffd white smoke running on 3 pistons when i stopd oil all over the place which i knew straight away bottom end but any help into the cause of this would help much appreciated all and thankyou, i will rep all accordingly to everyone that attempts
but my thinking could be fpr not installed and uprated fuel pump
Last edited: