started gettin my stuff what am i missing...

[starlet666]

emanage....ultimate
awaiting harnesses atm
injectors
turbosmart fuel pressure reg
big coil pack
shift light
launch control
pistons??? undecided atm what brand
rods
full gasket kit
thermo fan controller with digital real time read out


should i get new valves or not the ones i have are fine but im raising the limiter a tad so revs are bein set at 8300-8500
...
anything i may have forgotten

 

[Dave@TM-developments.com]

Valve springs and a fully lightened and balanced crank

 

[starlet666]

havin trouble finding any cranks there is nuthin here at all mate just goin 2 get mine done i think... and yeh valve springs is a given...anything else maybe

 

[Toby@ToyTuning.com]

Just engine or do you want chassis/brake recommendations as well?

If your going for a set of valve springs then you really need some cams. What have you already done to the car as that will help us inform you, also what turbo?

Thanks,

T

 

[starlet666]

got a gt2860rs turbo on it custom mani full exhaust 2 3/4 inch...
not much else atm was goin 2 put the 5e cams in it cause i dont really wanna go to far atm got a bit of a tight budget for this build and aiming for around 300 hp max
its my daily after all

 

[Toby@ToyTuning.com]

Ah I see, the 5e cams will make a small difference but better than stock, we also do re-profiled units if you need which are well priced. You can also consider lightweight pulleys that we also sell which will reduce the rotational mass. Piston wise Wiseco low comps will be good with Scat rods which is what we supply to most of our rebuilds.

Also an uprated fuel pump unless you have already bought one

T

 

[starlet666]

yeh got the pump i have a walbro in tank...
and i cant afford the postage from u guys... when i supply alot of the stuff
im thinkin about ross pistons with a 8.2:1 c/r
and ths rods atm

and a graphite head gasket... dont know how much boost it will take though
and ajusa head bolts

 

[TurboDave]

What about a clutch?

 

[starlet666]

yeh got that in mind
just gotta find out what is in there it certainly aint stock
its hard as a mother fucker get a workout on that leg driving to work every day

 

[Toby@ToyTuning.com]

With 300hp you will have to work those legs out only option really, ORC309 will be fine and isn't too bad I use one everyday in our demo car no2. Where abouts are you in the world?

T

 

[starlet666]

australia matey and if i get a new clutch it will b a exedy or a extreme clutch not a jap one stupid priced and our aussie ones are great...