turns over but not starting!

[smythy75]

any deas guys?

im getting fuel and spark but she wont fire up!

am i missing anything obvious?

its timed right and all! sparking ok and fueling ok, i just cant figure out why she is turning over and over and wont fire, keeps flooding just!

Peter

 

[_GAZ_EP85_]

You sure you def getting a spark

 

[HYBRID]

ok possible list of problems:

map sensor plug disconnected
water temp sensor plug disconnected
low battery
cracked rotor arm or dizzy cap
efi fuze blown or dislogged
clips on ecu not on propperly..

just a few things from the top of my head pete

kon

 

[smythy75]

110%%%

 

[HYBRID]

read above lol

 

[smythy75]

ill check that list of probs kon!

dizzy and all is fine, as i said, im gettin spark an all ok, had the cap of today an all cleaned etc and def gettin spark! as for the other things ill def check them all.

 

[HYBRID]

u didnt happen (by some slim chance) to have switched a lead round on the dizzy? or perhaps the rotor arm isnt making contact?

worth a look bud..

 

[spuddy]

Are the plugs fowled?

 

[smythy75]

wot do u mean spuddy?

kon the leads are all on ok and still sparking!

 

[smythy75]

i just wanted to start this up to see if it would fire, i dont have a rad on it or anything yet! would this not let it start?

 

[HYBRID]

it should start.. well mine had without a rad...

 

[smythy75]

thats what i thought!

the list of probs u gave me, can u write beside them their locations on the car (ep82)

 

[HYBRID]

map sensor plug disconnected on the firewall next to the map sensor
water temp sensor plug disconnected iirc on the gt its the one on the left, 1st sensor u can see on the "front" of the thermostat housing.. its a grey plug
efi fuze blown or dislogged in the fuze box in the engine bay
clips on ecu not on propperly.. next to the ecu?

 

[smythy75]

I check all that and seems fine

 

[HYBRID]

did u check the rotor arm to see if its on well?

just by some great chance u didnt happen to change the setting of the dizzy (ie adv or retard) when u opened it up ? coz that could cause ur problem if its so retarded that it couldnt start..

just troubleshooting here lol

 

[weakboy2]

put a few drops of oil in each plug hole, put the plugs back in and try and start it with your foot flat on the accelerator, dont take your foot off until its away.

 

[smythy75]

ta for help. ill try in morn again

 

[goldenvtr]

done a compression test?

 

[smythy75]

fresh build

 

[goldenvtr]

fresh build

still mate, i thought the same problem, tried everything but tirned out i only had compression in 1cynlder!