christyep91
Lifer
hi water is getting in to oil compression is good on engine and the turbo was checked did this happen to anyone before:
water getting into oil
- Thread starter christyep91
- Start date
christyep91
Lifer
3 cylinders 160 and one is 150
christyep91
Lifer
compression is not bad though fills the intake manifold with water could it be something wrong with that
christyep91
Lifer
i should have said that this a second hand engine the first engine had the same symptoms after the head gasket had been just been replaced.
we just assumed the block had warped.
this is whats the problem with both engines i filled the engine and rad 3 quarter full and started the car
when i completely topped it up it up it cuts out within ten seconds
i took the plugs out there wet
will run perfect with no water
i bypassed the turbo coolant to see if that was the problem its a tong hybrid i remember there was a few of those recalled over some problem i cant remember
(and i made sure to let the engine cool plenty and use hot water to avoid crackin anything)
could there be anythin wrong inside the inlet mani????
we just assumed the block had warped.
this is whats the problem with both engines i filled the engine and rad 3 quarter full and started the car
when i completely topped it up it up it cuts out within ten seconds
i took the plugs out there wet
will run perfect with no water
i bypassed the turbo coolant to see if that was the problem its a tong hybrid i remember there was a few of those recalled over some problem i cant remember
(and i made sure to let the engine cool plenty and use hot water to avoid crackin anything)
could there be anythin wrong inside the inlet mani????
christyep91
Lifer
thats one idea
problem is im not actually near the car
so if your readin this muppet head check those pipes
problem is im not actually near the car
so if your readin this muppet head check those pipes
MARK@CMBAUTOS
Trader
christyep91
Lifer
its running now the pipes were wrong on the inlet.
the big ends are gone on it now we only had it running no length
the lad we got it off said he put a brand new set of bearings in it
it was tappin a bit wen we first started it and thought it was just comin from the cams and would go out of after drivin it for a bit
but it just started knockin bad
the big ends are gone on it now we only had it running no length
the lad we got it off said he put a brand new set of bearings in it
it was tappin a bit wen we first started it and thought it was just comin from the cams and would go out of after drivin it for a bit
but it just started knockin bad
corofin12345
Member +
christyep91
Lifer
its not my car its a friend of mine
we got the engine off a lad off here...now he wont answer the phone or his messages
we got the engine off a lad off here...now he wont answer the phone or his messages