Hi guys, in relation to my last post i have figured that the rpm signal wire must be incorrect to a degree?
When looking at the apexi instructions it gives 2 rpm signal wires - one for ordinary (rpm1) and one for multiple (rpm2). which one should i wire in?
currently ive gone for rpm 1, and am getting a minimum of about 4000 rpm on idle instead of 1200 rpm which the rev counter was reading?
Also will this affect the running of the car, as everything else seems to be fine otherwise?
Cheers
Mikey
When looking at the apexi instructions it gives 2 rpm signal wires - one for ordinary (rpm1) and one for multiple (rpm2). which one should i wire in?
currently ive gone for rpm 1, and am getting a minimum of about 4000 rpm on idle instead of 1200 rpm which the rev counter was reading?
Also will this affect the running of the car, as everything else seems to be fine otherwise?
Cheers
Mikey