Looking for a bit of advice from anyone with experiance installing these.
The harness comes with twin core shielded cables for the triggers (one for the 24 tooth signal and 1 for the 1 tooth signal). I'm splicing the MS loom into the oe loom so if I have to then I can plug the stock ecu back in but on the stock loom there are only 2 wires, G- and G1 (G2 has been made redundant), yet I have 4 coming from the MS loom (2 twin core cables).
Can anyone shed any light on how this should be wired? Do I have to run the twin cables directly to the distributor?
Good help will be repped
alan.
The harness comes with twin core shielded cables for the triggers (one for the 24 tooth signal and 1 for the 1 tooth signal). I'm splicing the MS loom into the oe loom so if I have to then I can plug the stock ecu back in but on the stock loom there are only 2 wires, G- and G1 (G2 has been made redundant), yet I have 4 coming from the MS loom (2 twin core cables).
Can anyone shed any light on how this should be wired? Do I have to run the twin cables directly to the distributor?
Good help will be repped
alan.
Last edited:
