Wiring up my boost guage, help needed.

[Skidz]

Hi.

I want to fit a g-reddy boost guage to my gt but I'm not sure how/where to wire it in. I had a search but could'nt find a how to guide?

I know how to fit the t-piece and thread it into the car, just not sure where to put the wires! Ideally I'd like it to only light up when my lights are on.

Any help would be much appreciated, rep points waiting

Cheers

 

[Sigma]

Take a feed from the wire which becomes positive when the sidelights come on, to the binnicle.

The earth could go to the collective behind the binnicle too.

Anybody know the colour of the illumination feed for the binnicle for Skidz?

 

[davehart]

If its an electronic one from Greddy then you can wire them all into the back of your stereo.

That should have a 12v constant, 12v ignition, earth and one for the light. Wire it up there and the light will come on when you put your side lights on.

Easy peasy but just you can check the voltage with a reader to make sure as the co,our of the wires can be all over the place I found.

 

[Skidz]

Thanks for the info guys, with that in mind I'll give it a go :beer:

Dave - I've rep'd you

Sigma - Says I can't rep you until I spread rep around more. Must be because you've helped me in the past !

 

[Sigma]

You probably have done, then, lol

I'll take it as a mental rep