priming turbo

K

ktl

Member +
I understand i have to remove the main king lead to stop the car from starting..

but where do you put abit of oil in the turbo before cranking the car ?

UKSC says the inlet but thats where the intercooler pipe goes and wasnt sure if thats correct ?

If i could get a full instruction that will be very helpfull for tomorrow fitting :)
 
K

ktl

Member +
PICT0002.jpg


Just took a picture. Do i put oil in the left inlet(pipe going to sump) or the right inlet ?
 
dac69er

dac69er

Super Moderator
the port on the right of the pic is for the coolant.

on the left hand side port there is a large hole (return to sump) and a smaller hole which is the oil feed in. i would put a bit in both the feed and return holes, give it a good spin by hand to get it in there a bit.
 
dac69er

dac69er

Super Moderator
on a GT is the last fuse at the bottom in the engien bay. its 15A.

should be called EFI if you look on the lid
 
You must log in or register to reply here.
Top