EP91 Glanza cluster to EP82 loom?

yiph

Member +
Hi,

If I transplant the EP82 4EFTE engine, ECU and wiring loom into an EP91 body, to put in the EP91 Glanza cluster, would the tacho still work?

Do they share the same type of rpm signal from the distributor? I've tried hooking up the Glanza cluster in it, nothing on the tacho. Put in an aftermarket rpm gauge, worked. Signal pickup from ECU pin-out.

Thanks
 

dac69er

Super Moderator
the signal will be the same, but the pinout position is probably different. just take the rpm signal straight to the rear of the cluster!
 

yiph

Member +
I've got the rpm signal going into the -IG terminal. Doesn't seem to work.

Does the tacho need its own power? I think I put in +12V into it, and still doens't work.

Could I have a busted tacho?
 

weeJohn

Lifer
I've got the rpm signal going into the -IG terminal. Doesn't seem to work.

Does the tacho need its own power? I think I put in +12V into it, and still doens't work.

Could I have a busted tacho?

Did you put a ground onto it also?
 
Top