Recent content by bender

  1. bender

    Centre controls fuse ( AC, HEATER FAN)

    Thanks JAY, i have read there is two fuse boxes inside the car, one behind the radio/,dash and one behind the kick panel? Ill check both, cheers
  2. bender

    Centre controls fuse ( AC, HEATER FAN)

    Hi guys, was testing my radiator fan and think i blew a fuse, tested the connections for radiator fan and after driving the car the vents dont blow any air in any setting, the AIR CON and ECON button no longer light up green as they did before also my vent controls do not light up as they did...
  3. bender

    HELP! Heater Fan Not Working!

    i have a similar problem, no controls work (hear the vents moving when i press the buttons) no air will come out of vents (hot or cold) and no lights on the AC / AIR CON button, is there a fuse that controls all this?
  4. bender

    how to test radiator fan glanza V

    Could this be caused by my fan being bad, and the relay is constantly trying to start it?, my fan will come on when the AC is turned on, but that is only at half speed i believe. any one have any input? i think im getting closer
  5. bender

    how to test radiator fan glanza V

    update: i tested some connections, i tested the power wire from the cooling fan to the relay, the relay wire that runs to the coolant fan sensor; they both checked out for continuity. when i run the engine with the coolant fan sensor off, and ground that i hear a clicking sound from the...
  6. bender

    rad fan re-wiring assistance

    Thanks, yeah my glanzas fan will turn on with the AC on, so the fan itself works, ive ordered a new cooling fan sensor, is there a way i can test this sensor in the meantime?
  7. bender

    how to test radiator fan glanza V

    I read on another old post that the glanza has different wiring scheme then starlet GT in regard to the cooling fan system, my thermostat housing only has one plug (1pin) and looks like it goes back to the cooling fan relay. if this is the fan switch sensor then where is the coolant temp sensor...
  8. bender

    rad fan re-wiring assistance

    did you guys figure out where these wires go? i have a glanza V and am trouble shooting my fan not running, the fan will run when i turn the AC on but i dont believe it is coming on when engine reaches operating temp, does the fan always kick in on your drive or only in the sweltering heat? My...
  9. bender

    how to test radiator fan glanza V

    I can unplug this for the meantime and all is good while i figure out what is causing the fan to not turn on? Thanks SKINY I think i need to sort a half radiator too as i have manifold, ct9 hybrid and screamer pipe that came with the car a little reluctant on installing though its completely...
  10. bender

    how to test radiator fan glanza V

    Do you know where the aircon plug is normally located, can probly find it when i have a look later. Also are you running that aftermarket fan with stock radiator? Thanks alot
  11. bender

    how to test radiator fan glanza V

    Thanks will test these when i get home tonight
  12. bender

    how to test radiator fan glanza V

    Thanks guys will try these tonight, willing to bet something else is messed because when i turn my AC on the cooling fan kicks in along with the AC fan. So it seems my car wont turn the fan on when it reaches operating temp. Do you guys think the car is just not reaching temp for the fan to kick...
  13. bender

    how to test radiator fan glanza V

    Hi everyone greetings from Vancouver Canada, i recently bought a glanza v and am trying to fix it up.... i am trying to diagnose my radiator fan i feel like it is not kicking in when reach operating temperatures. the car is completely stock. sometimes i turn the engine on(warm) and hear the fan...
Top