Recent content by The Last Streetfighter

If your temp needle is over half way and your fan is not coming on, there is your problem right there. (Having said that, with no fan, and in 35dec C heat, my car won't overheat if I am doing over 60km/h) My problem was that the plug for the thermofan had cracked and occasionally the wires in...

http://www.cars-directory.net/specs/toyota/starlet/1996_1/4694/ 8.2 compression ratio and spec says Unleaded Regular Gasoline. If you advance the timing more than the standard 10 deg (15 or so) or your engine is pinging under load, then you should use 95 or 98 RON. If you have not done...

You do not need a FCD if you have the EMB (and tune it properly.) You also don't need a FPR unless there is something wrong with yours.

http://www.jzs147.com.au/forum/viewtopic.php?t=5675

http://www.toyotagtturbo.com/forums/showthread.php?t=47

Is that TPS thread by weejon and GV1.3 for the p82 or for the p91?

Is there a side by side pic?

You don't need a wideband to run the EMB. But if you want to Home Tune it (instead of taking it to a dyno) then the Wideband is recommended.

If you put on a TD04L with it's own actuator, why would you buy a HKS actuator? Emanage Blue and Ultimate will remove the boost cut (by clamping the MAP signal) You would only get Boost Creep if you keep the CT9b and up the boost with free-flowing mods (intake exhaust etc). The TD04L...

Turbo pressure sensor is the MAP sensor as indicated by large yellow arrow in the photo.

http://www.greddy.com/tech/ The 7th and 8th items down on this page are a good start.

Follow the emanage instructions for installation and jumper settings and then set everything to 0 changes. There should be instructions for a full reset. Will run like stock. Then drive it to the tuner. Also make sure you have the latest firmware for it ;)