dizzy cap n rotor arm leads change but is still the same. fuel pressure goes to 35 psi. compression test have nt been done do u think its neccesary. Seems all injectors r working well. Any clue mate . . . . thnx
hi guys, my car is very heavy to go from 2000 to 3500 rpm and it sounds like subaru. Am runing a ct9 stock. This hapen after changing the 4 piston as i hav blown them up at 1.1 bar. Any clue is appreciated thnx
Hi there after fitting my fpr set to 43 psi on a ct9, the car seems to b a bit heavy to go. I have notice when i accelerate the frp setting seems to go from 43 to 50 psi, is it ok. And does the lenght of the hose from the fpr and the fuel rail make the car to become heavy, as mine is a bit...
Hello, when my car is cold (means not yet reach the middle of high and low temp range) the car does not goes smoothly at any gear, this happen only below 2000 rpm and above 2000rpm it goes well. I ve change the map sensor but its the same. Any help appreciated, rep added too
Yes it seems like an emptyness in the accelerator on the second and third gear before it run. And sometime at 150km/h when u put neutral gear the engine just goes off.