Search results

Do you have a manual for a 4efe engine

Kindly sent me the manual.my email ngoma.dalitso@gmail.com and Watsup number +260969601777

I was asking about the resistance of the ignition coil.the main problem I am facing with my starlet is that the forth cylinder is not firing.the engine is having a misfire

Hi All What are the standard resistance values for the distributor coil? My Distributor has a problem. How can I troubleshoot and repair my Distributor for my 4efe engine?

I changed the oil pump and put a new one but it the oil light keeps coming on

Okay noted.Another issue I am facing is oil sensor keeps coming on and off.when I rev the oil light turns off and when you it is on idle it turns on.i have tried to change oil sensor and the oil filter.but still it does the same.what can I do to solve this issue?

Yes I need to adjust the rpm

My Toyota starlet GT does not have a rev meter how can I adjust it's revs

My Toyota Starlet loses power uphill what is the problems? It's loses power in 4th gear

Does an exhaust manifold leak causes very bad fuel consumption?

Hi James Is it okay for my IDL voltage from ECU to show 4 volts when I measure with the multimeter? My starlet engine stall whenever I press accelerator pedal very much.so I test the 3 terminal TPS connector from ECU when I switched on the engine and these where the results PSW 5volts E1...

Thank you James

Is it okay for my IDL voltage from ECU to show 4 volts when I measure with the multimeter? My starlet engine stall whenever I press accelerator pedal very much.so I test the 3 terminal TPS connector from ECU when I switched on the engine and these where the results PSW 5volts E1 0volts IDL 4...

Can you please Send me a copy? My email ngoma.dalitso@gmail.com

Please send me

Wow that's nice huge relief for me.i won't buy an O2 sensor

Hi Jay Please send me the images if you can separately

When I measure the voltages on my TPS connector my PSW is 5V,My ground is 0Vand my IDL pin is 4v.i know my PSW and ground voltages are okay but I am not sure about my IDL voltage(4v) is it okay? From research I read it is supposed to be closed to zero

Your fuel consumption is okay even without the O2sensor?