Search results

turns out the fuel filter was dirty, put a new filter, car now has 38psi fuel pressure at idle, 43 when throttle is opened up.

I am using an old used toyota fuel filter and pump is original stock from this tercel.. I may try to check fuel pressure, but i cant explain My 9:1 afr at idle.. Way too rich for stock tune?

I have two. I just bought one, and it worked on the sellers Car..

Is it possible that something within the ECU has gone wrong? When i bought my paseo with this motor swapped into it, the motor failed the first day I had the car, under severe load, only at 9psi, but i melted a #3 piston quite badly. I had initially blamed the OEM manifold for the restriction...

So i readjusted the TPS, it's good now, but cannot get the car to fire up and idle on the 4EFTE map sensors, it will fire and idle on the 5EFE map sensor without issue.. AFR's are at 9:1 at idle and i tried to drive the car down the road but it was way too lean to move practically, the AFRs were...

I am running a 2 plug 4efte ep82 ecu, The car warms up normally and into the 180-200*f range and then the fans come on.. And i took EGT readings with a laser temperature gun i have and i am getting these readings Cyl1: 300, 500, 500, 300, degrees fahrenheit. with a log manifold, should all...

Hi guys! Firstly, this EP82 4EFTE swap ran perfectly in my paseo, now I have switched it over to my tercel, but turned it into a 5EFHTE.. 5EFHE, CT9, custom mani, 4EFTE electrics I have had issues with the car having no throttle response. The moment i try to open the throttle above idle it...

pm'd

Pm`d about manifold!!

Good communication, probably not the cheapest way of int'l shipping but it came in good time!

Yeah no problem standard manifold won't cause any issues.... Right

Still have these available?

I see a picture of Aluglide and then duraglide, what are we buying here?

I was looking on my local shop's site, and I found a flange for a CT26 with the divorced IWG port. Looks like a CT9 flange to me! What do you guys think? This is the stock CT9 here..

And what would the thread for the oil filter/ sandwich plate fitting be?? I read 3/4 16unf somewhere, correct? I would think it would be metric.

Great thanks!

I have searched but I was wondering if someone would be able to quickly verify what needs to be done. I want to run an oil pressure and temperate gauge, both with electric senders, my 4EFTE has no Aircon, just power steering, can I use a sandwich plate to install these 2 senders, or will...

The ST202 isn't a 5 bolt hub? A bit confused as to where you found the discs. thanks =]

What model did these come from if you don't mind me asking friend!

This thread scares me! I lost compression on my stock boosted EP82 4EFTE last week on Cylinder #3, i'm very close to pulling the head, and just PRAYING that the stock manifold melted a hole in the top of the piston, and didn't scratch the bores.