Search results

  1. Z

    which starter??? 5e

    Hey folks, Installed my 5efhte engine today. But when i cranked it it maked a really scraping noise. I think it comes from the starter, tooth grinding. I used a 5e flywheel with a 200mm clutch and the 4efte back plate.. which starter do i need? Because with the 4efte starter it sounds like...
  2. Z

    new Scat conrods €300

    S
  3. Z

    bad mileage

    Hey guys, i'm running a 98 glanza with the following mods: Manifold downpipe 2'5" exhaust hks actuator Fmic blitz sus filter aem tru boost set on .85 bar the problem is i only do 280-320 kilometers with a full tank.. last time i drove 200 kilometers wit a speed of 100kmhon...
  4. Z

    blitz/jam ecu glanza

    As above, i'm looking for a blitz or jam ecu for my 1998 glanza. pm me ur price delivered to the Netherlands :) Cheers Erwin
  5. Z

    Which timing 5e

    Hey, i have a 5efhe engine, with 4efte pistons and 4e camshafts.. But on which timing should i set it? 4e or 5e? Cheers Erwin
  6. Z

    2.5" exhaust, manifold, downpipe

    Hey, i'm looking for a 2.5" exhaust for my glanza, also manifold and downpipe (not ebay) Let me know if you have something
  7. Z

    5efhte clutchkit

    Looking for a 5efte clutchkit for my daily.. So if you have one let me know
  8. Z

    turbooooo

    Hey guys, i'm building a 5efhe turbo engine, and i have a wepr td05h kit, but lot of people say it's laggy.. So i'm thinking of a other turbo.. But now is the question what turbo to get.. I'm thinking of a Garrett gt28rs or a IHI vf turbo.. But which one is the best, I want little lag...
  9. Z

    Toga upgraded oilpump 5efhe?

    Hey, i have a 5efhe engine, and I want a Toga oilpump. But i see that there are 2 different types. One normal and one if you have california emision stuff.. But i don't know which one i need.. How can i see which one i need? Greets Erwin
  10. Z

    turbo for efhe

    Hey, i'm getting my 5efhe ready for turbo. And i have a wepr td05h 16g kit lying around. But isn't that a bit laggy? I read it spools by 47-4800rpm.. What is a good turbo with a earlier spool for the 5efhe? Greets Erwin
  11. Z

    torque moments 5efhte

    Hello, i want to start building my 5efhte engine, but which torque settings do i have to use? 5efhe or the 4efte? Greets Erwin
  12. Z

    diagnostic test, code 31

    hey, i did a diagnostic test on my glanza v, and code 31 was the result. Code: 31 Signal: Vacuum sensor Diagnosis: No signal at Vacuum sensor (PIM) Common Trouble Area: Vacuum sensor to ECU what is the problem and how can i fix it? greetings, Erwin
Top