5efe conrod with 1G-GZE piston with A/R60 M24 T28

M

mechiel

Member +
hi all,

I'm currently rebuilding my block. One of my previous FHE rod is burnt, but I can't find any replacement anymore over here, thus I'll be using FE rod to match with my 1G-GZE piston. With a turbo from Garret T28, what is the safe side bar pressure I should put on the turbo? 1bar?

Thanks in advance.
 
E

elton

Member +
if budget allows, order a set of forged 5e rods since your 1g piston is known to take up to 1.7bar
 
1

117

Fresh Recruit
uhh.... not sure what the issue is... seeing how i see stock bottom end fhe's handle 300hp with a good tune

heck, i see an fhe running running 22psi out of a t3/t4
 
S

Skalabala

Member +
117 said:
uhh.... not sure what the issue is... seeing how i see stock bottom end fhe's handle 300hp with a good tune

heck, i see an fhe running running 22psi out of a t3/t4
Click to expand...

He has 5efe rods, and 1.2bar with that turbo will give him in the region of 260hp.
Doubt that 5efe rods will last long with that power.
 
You must log in or register to reply here.
Top