will_maddox
Member +
Or full head with shims and buckets?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
5efhe cams
- Thread starter will_maddox
- Start date
skevosEP91
Member +
With stock head and 5efhe cams i made 310 whp on a 4e mate ... I think it depends what you need from your setup
will_maddox
Member +
With stock head and 5efhe cams i made 310 whp on a 4e mate ... I think it depends what you need from your setup
Hi there, got forged motor (stock c/r) td05 billet wheel 3" exhaust
On the dyno we noticed valve bounce from the tired old vavle spring and only made 297bhp
So i want to refresh a new cylinder head over the winter with new springs, light port, and 5efhe cams
Iv already ported the head i just need to figure out what cams i wanna use. I dont wanna complicate things with mad cams
skevosEP91
Member +
5efhe cams i think will be the cheaper solution and here we have them on another 5E Glanza outputing 360whp on massive 2.3 bar on a Gt3076R.... On that engine we noticed slight bog at hign Rpms but the car has a very large powerband ...
will_maddox
Member +
Getting a hold of a set isnt too much of an issue. It is sourcing the shims for the buckets thats the nightmare5efhe cams i think will be the cheaper solution and here we have them on another 5E Glanza outputing 360whp on massive 2.3 bar on a Gt3076R.... On that engine we noticed slight bog at hign Rpms but the car has a very large powerband ...