Apexi power fc ecu /auto tps-map

pantwd

Fresh Recruit
I'd like to ask if I can run the apexi power fc ecu (ep 91 by ap engineering) in my stock glanza ep91 manual gearbox, with auto map sensor and auto tps (4pin). Thanks
 

dac69er

Super Moderator
As standard the ap engineering ecu only accepts an on/off tps signal.
Without knowing the exact pinout of the ecu I wouldn't know whether there is the provision for a variable tps input, but I would say it's a no I'm afraid.

As for the map sensor, it shouldt be any different between manual an auto, but you can fit any 0-5v map sensor and just input the scaling values to get it to work
 

pantwd

Fresh Recruit
Thank you for your reply dac69er.
So, I must probably have to replace the oem 4pin tps with the oem full body 3pin tps?
 

dac69er

Super Moderator
That would be the best idea. I'm not sure if the auto tps has an open and closed position feedback with the 4th pin being the variable feedback? If so, it may be ok to keep it, as long as the pin o/p goes to the right pin on the ecu.
 

pantwd

Fresh Recruit
Does anyone know the apexi pfc harness pinouts? I want to check the ecu's signals to compare with my car's harness. Remind that my stock ecu is an a/t glanza with 3 connectors. Thanks guys
 
Top