thinking of opening up my engine for peak around can someone tell me the value of torqueing big ends. i read its:
stage1 20nm
stage2 40nm
now on another thread it said
Con-rod cap to con-rod:
29ftlb (18ftlb then +90 degrees)
29ftlb its in very close to 40nm so its fine, the other part 18ftlb then +90 degrees, is suposed to give you 29lbft after?
also does these are same for pauter rods?
stage1 20nm
stage2 40nm
now on another thread it said
Con-rod cap to con-rod:
29ftlb (18ftlb then +90 degrees)
29ftlb its in very close to 40nm so its fine, the other part 18ftlb then +90 degrees, is suposed to give you 29lbft after?
also does these are same for pauter rods?
