Bigger turbo setup and info. Any info would be appreciated :)

G

Gtturbo548

Fresh Recruit
Hi guys. Currently only running a ct9 on my gt but looking to go bigger turbo but on a slight budget (I know. It's never good)
This forum has helped all my previous issues so I thought I'd give this one a go :)

I have been offered a td05 with mani. Down pipe injectors and Fmic for 300 of a friend but just wanted to know did I need anything else, modification wise to make it run well.? Trying to avoid piggyback or standalone as cant afford at the moment but will get the fuelling etc setup on the rollers

The car is currently running:
Wossnor 74 .5 pistons
Scat rods
Acl bearings
Arp head bolts
1.4 mm head gasket
Air filter relocation
Hks fcd
Fmic
Front exit exhaust
Sps manifold
Sard rrfpr
Bailey dump valve
Hks actuator at 0.9 bar

Didn't know what setup to run avoiding ecu changes. As I said any info would be awesome

I was also going to get a gizzmo ebc and tial external waste gate.

Thanks guys
 
A

AdamB

Member +
Wouldn't bother until you can get management tbh, will run like shit as it will be so rich at the low end.
 
Gilly2006

Gilly2006

Member +
would be a nice setup, no harm in buying and fitting the kit and plodding around, but i would leave the injectors off until you get management.

should run good but i wouldn't be boosting about without management, and i would also ditch that fcd first chance you get.

i personally wouldn't touch gizzmo or any sort of cheap controller, i use an apexi avcr which is good, or try and go for a blitz controller.
What size injectors have you got - and what boost you planning to run? that will also determine what managment you need.
 
You must log in or register to reply here.
Top