Crank & bearings

[rongkeys]

I know acl bearings are recommended, just needed to know how much the crank can be ground/machined ie 1mm and would bearings be available. this is for the big end part of the crank (journal?)

 

[dac69er]

normal amount is 0.25mm. if it needs anymore than that i think its best to change the crank

 

[Skalabala]

you do get 0.5mm bearings. but as dac69er said, change it rather

 

[_iforget_glanza]

also worth noting mate the 4efe crank will fit the 4efte aswell

 

[rongkeys]

ok thanks for replys, I'm sure I've seen a data list for measurement will try the search again.

 

[Skalabala]

runing clearance sould be no more than 50 microns, thats all you need

 

[_iforget_glanza]

i hav a sheet withe the measurements mate if you want i can scan them and email u them or put up here?