diagnostic codes 12,14,24

[ashygt]

12 is no rpm signal,14 is no ignitionn signal and 24 is intake temp signal open or shut.

the reason being just got to work 2day driving slow because oil hadnt warmed up ,my car just cut out, started it up and it
idles about 300 rpm then just cuts out,it drives fine when your in gear but wont idle at all,does anybody know what this could be to check.also my oil pressure is fine.but just dont know where to check realy deciding to sell my car because of this.

thanks stu

 

[ashygt]

does no one know what it could be? dont know what to check.

stu

 

[Texx]

The first thing I would do would be to reset the ECU by pulling the EFI fuse or disconnecting the battery for at least 30 seconds. Then see if the engine idle has improved before checking for any codes that might have returned.

 

[ashygt]

just done this mate but still throwing same codes up my mate with an integra reckons it could be dizzy gone but i dont have a clue can anybody help it drives perfect in gear but when your in neutral or push the clutch in it just cuts out realy doing my head in.

stu

 

[ashygt]

getting auto electrician on it at the weekend because dont have a clue what it is thats making it not idle.

stu

 

[ashygt]

auto electrician came round said it most likely be the crank sensor so going to try another dizzy today hope it solves it because its doing my head in,the dizzy has done around 140000 miles because i swapped this one from my old engine onto my forged one.

stu

 

[ashygt]

yes problem solved idle control valve is knackered tried my mates off his starlet and it were idling and running fine so just need to buy one of these now,cant thank sam enough for doing this for me even though these idle control valves arent cheap.

stu