Where can i get a egt temp weld on boss/stainless steal
Starlet_Sam Moderator, Regional Area Reps Supervisor & Gay Car May 30, 2008 #2 Mine, or should I say yours , was drilled and then tapped. Will the stainless be think enough to do this?
Mine, or should I say yours , was drilled and then tapped. Will the stainless be think enough to do this?
Rory Lifer May 30, 2008 #4 Get one made up from a local engineering place. I could get you one made up possibly? or go to your local DIY store and buy a 1/8npt fitting, in stainless. Job done.
Get one made up from a local engineering place. I could get you one made up possibly? or go to your local DIY store and buy a 1/8npt fitting, in stainless. Job done.