Following on from my other thread I'm not starting on the engine loom. I'm using the same PDF document on here as a reference and just want to make sure what I'm about to remove is ok and won't mess up anything else.
So from the document here is what I'm looking at removing :
48 - HVAC Module
50 - Sub harness connector
51 - Vacuum switch valve
52 - Idle up valve
57 - Unknown (Goes to ecu so not sure if I can remove?)
68 - Coolant sensor to HVAC module
79 - Vacuum solenoid valve
85 - A/C pressure switch
88 - Radiator fan (not sure if this is engine fan or A/C fan)
90 - Ambient Temperature sensor for HVAC module
Understand most of this is to do with the A/C but am unsure if I can remove that HVAC module or if it does other things as well as A/C?
Thanks
Adam
So from the document here is what I'm looking at removing :
48 - HVAC Module
50 - Sub harness connector
51 - Vacuum switch valve
52 - Idle up valve
57 - Unknown (Goes to ecu so not sure if I can remove?)
68 - Coolant sensor to HVAC module
79 - Vacuum solenoid valve
85 - A/C pressure switch
88 - Radiator fan (not sure if this is engine fan or A/C fan)
90 - Ambient Temperature sensor for HVAC module
Understand most of this is to do with the A/C but am unsure if I can remove that HVAC module or if it does other things as well as A/C?
Thanks
Adam