FCD, Vanity Tray, Whiteline Panhard

Status
Not open for further replies.

Ian_w

Member +
For sale: HKS FCD

Item Condition: Works when used last november, sat on a shelf till now. Wires were cut and spliced into the loom.

Price and price conditions: £35 + postage + paypal, unless picked up.

Extra Info:

Pictures: http://ianw28.pwp.blueyonder.co.uk/DSCF3383.JPG

Contact Details: PM

Location: North east england, near newcastle

Delivery & Conditions of Delivery: First come first serve, tell me where you are, i'll get a postage price.

----------------------

For sale: EP82 Vanity Tray

Item Condition: Very good - could do with a clean for the perfectionist

Price and price conditions: £40 + postage + paypal, unless picked up.

Extra Info:

Pictures: http://ianw28.pwp.blueyonder.co.uk/DSCF3382.JPG

Contact Details: PM

Location: North east england, near newcastle

Delivery & Conditions of Delivery: First come first serve, tell me where you are, i'll get a postage price.

----------------------

For sale: Whiteline panhard rod

Item Condition: Not tried to adjust it, been spraying it with some WD40. Bushes seem OK to me, but im not an expert on these. Original paint is flaking off. It was set to go on my car lowered at 60mm.

Price and price conditions: £40 + postage + paypal, unless picked up.

Extra Info:

Pictures: http://ianw28.pwp.blueyonder.co.uk/DSCF3381.JPG

Contact Details: PM

Location: North east england, near newcastle

Delivery & Conditions of Delivery: First come first serve, tell me where you are, i'll get a postage price asap for you.

----------------------

Images are high res to people can take a very good look at items.

I've been keeping these parts as i was after another EP82, but i've bought an S14 so getting rid of the final lot.

Ian.
 
Last edited:

Idrees

Banned
I'd snap that vanity tray up if I didn't have so much shit on my dashboard, AVCR gauges etc. :( Good luck with the sale.
 

Ian_w

Member +
FCD sold pending payment.

Vanity tray gone.

Panhard available, is this too expensive for the condition? It still solid, and i've kept the threads oiled up so it should adjust no problems.
 
Status
Not open for further replies.
Top