flywheel question

[5p1ff]

Im not too clued about gearboxes but can a 4e clutch kit fit a 3e flywheel. i Have a 3e gearbox bell housing on a RunX gearbox not sure of the code and the 3e flywheel is drilled to fit 5e block. I read the 3e/2e flywheel is a ton heavier than the 4e but can the clutch kit fit each other.

I am assuming my clutch is failing as when i run full boost my rev counter goes up but my speed stays the same.

 

[5p1ff]

Im not too clued about gearboxes but can a 4e clutch kit fit a 3e flywheel. i Have a 3e gearbox bell housing on a RunX gearbox not sure of the code and the 3e flywheel is drilled to fit 5e block. I read the 3e/2e flywheel is a ton heavier than the 4e but can the clutch kit fit each other.

I am assuming my clutch is failing as when i run full boost my rev counter goes up but my speed stays the same.

bump

 

[Harvey]

Is it a C series gearbox? Presume it is, so it should be fine.

Is it a 3E or 3ETE flywheel??

I think 3E takes a 200mm clutch like the 4EFE/5EFE/4AFE/ some 4AGE etc etc

3ETE is 212mm like 4EFTE/most 4AGE/ few others

Thats the main thing is the check if its a 200 or 212 clutch.