fmic kit fitted... blocking old b/o valve hole etc...

[steveglanzav]

what has anyone done about the old dumpvalve when fitting a front mount??

ive left it on the efi pie and taped up the outlet hole that used to go to the hot pipe, is this bad for my engine, also is ther a better way of sealing this hole??

getting quite a bit of squeeking as i accellerate??, im guessing this is dude to some air escaping??

any help rep added!!

 

[Stulet-GTT]

Take it off the EFI pipe an glue a 2p over the hole it fit just right, this is wot i done to mine till i relocated the air-filter an got rid of the efi pipe...

 

[scot-ish]

i have seen one that had the BOV took off, and a 2p glued over the hole, im not recomending this, but have seen it done lol

 

[Mike D EP82]

i just cut a bit meta and shaped it and seaed it on with tiger seal

 

[Stulet-GTT]

Sorted...

 

[Stryfe_NZL]

I got a bung that came with my BOV when I bought it for that hole, it was a nice polished alloy one too...

 

[sam starlet]

at the mome im just running an open turbo with a mesh over the top, sounds awesome and the efit pipe is so restricting! sounds awesome when spooling up too !!!

 

[Sheldon]

I got a bung that came with my BOV when I bought it for that hole, it was a nice polished alloy one too...

i got one like that.. but i dont use the efi pipe lol.

the 2p will look great polished!! lol

 

[ChrisGT]

Use a £2 coin, much better than 1p.

 

[scot-ish]

Use a £2 coin, much better than 1p.

hope so, the 1p disapears down the hole, and the tubby dont like that lol

 

[carrington865]

 

[durmz]

i had a 2 pound coin super glued on mine before haha, got some funny looks when seen, moddings expensive aye, 2pounds and everything!

 

[YoungStig]

i have seen one that had the BOV took off, and a 2p glued over the hole, im not recomending this, but have seen it done lol

me woop woop:rockon:

try sticking some little mascot on the 2p

 

[steveglanzav]

=D

me woop woop:rockon:

try sticking some little mascot on the 2p

like the idea!!