GT side skirt brackets

SKINY

SKINY

Lifer
I know I know, Hens teeth
But if anyone does have some can I have some pictures and dimensions or the brackets themselves
:)
 
SKINY

SKINY

Lifer
I sent a picture to The welder and he said he could replicate them for me, and the Legend strikes again with a great set to work too :)
 
quigs1982

quigs1982

Member +
it would be handy to have the measurements of them and pictures even for anyone else looking to get brackets made up
 
Calum122

Calum122

Member +
@SKINY I ended up making some 'cause mine were rotten

EV8JFxc.jpg
 
SKINY

SKINY

Lifer
Yea they don't look that hard to do to be honest, might look at getting some alloy bender blocks, it's been many many years since I did or had the inclination to do any metalwork, it's easier to pay someone lol
 
Calum122

Calum122

Member +
SKINY said:
Yea they don't look that hard to do to be honest, might look at getting some alloy bender blocks, it's been many many years since I did or had the inclination to do any metalwork, it's easier to pay someone lol
Click to expand...
I think I spot welded the rotten bits onto a formed piece of steel :D Which is why it looks pig eared. Just so it had the mounting bits for the side skirts.

I appreciate this could have been made a lot nicer, but as far as I was concerned it was just something you'd never see, function over form...
 
SKINY

SKINY

Lifer
Picked a mint set up from Jay on Sunday too give the welder to replicate, I have a bit of alloy L section here for the top of the stairs and it's not that far away shape ways, would just need a slight bend in a few places, the holes are not a problem either I've small files for the square 1s so I may have a bash at them :)
 
You must log in or register to reply here.
Top