Help!!!

[P-ROONEY]

Anyone tell me where the codes are for conrod bearing

thanks..

 

[Corey_gt]

13202 BEARING SET, CONNECTING ROD
13204-11030 4EFTE..EP91; U/S 0.25


http://www.toyodiy.com/parts/p_J_1999_TOYOTA_STARLET_EP91-AGMQY_1301.html

I think you should go into Toyota with your chassis number though as I think there are different sizes of bearings.

 

[350ep70gr]

Anyone tell me where the codes are for conrod bearing

thanks..

Size for conrod bearings should be stamped under the bearings. And should be numbers like 1,2 or 3. If you can not read those numbers then also check where the sump seals near the gearbox. Should be stamped on the block. From the one side 4 numbers which are the con rods. (2232) and on the opposite side 5 numbers which are the main bearings for the crank. (23322).

Hope you get it.

Chris

 

[P-ROONEY]

size for conrod bearings should be stamped under the bearings. And should be numbers like 1,2 or 3. If you can not read those numbers then also check where the sump seals near the gearbox. Should be stamped on the block. From the one side 4 numbers which are the con rods. (2232) and on the opposite side 5 numbers which are the main bearings for the crank. (23322).

Hope you get it.

Chris

thanks chris

 

[350ep70gr]

thanks chris

Welcome mate.
Better way to determine bearing size is the micrometer way tho. Mesure the journal of the crankshaft and then mesure the rod cell (big end) with the bearing inside torqued to the right specs wich are from memory near to 29 ft/lb figure. Then you know the clearense and can find what bearing size suit you better.

Chris