how to set fuel cut level on pneumatic fcd

[glanza/001]

hi all purchased a turbo smart fcd pneumatic type and nt too sure how to set it any ideas please

 

[dac69er]

i would take it to some one who does mate.

if you get it wrong and dont know what your doing you may piss up the engine.

is there no instructions?

 

[glanza/001]

yeah just says to find the map sensor witch is located under the bonet.the one with the preasured pipe with 3 wires going into the loom.with the pneumatic type there is no need to cut and splice wires to the ecu.just has a clamp dial on the top with plus and minus on it.iam not intending to wack the boost right up just a little tilln i get sum pennys together for the full monty

 

[glanza/001]

plz plz plz

 

[munday]

Just set it to fully closed, then open it up a tad and go for a run, if you hit fuel cut open it up a bit more etc.

As usual, make sure you have the correct fuelling mods blah blah blah its been said numerous times on this forum so it shouldnt really have to be repeated

 

[glanza/001]

cheers fella

 

[hardcoreep]

I tried this, using my boost controller once. It bleeds off the pressure before the MAP sensor so it doesnt see the same signal. Ran my car lean as hell. Tell us how this goes.