WallaceGlanza
Member +
Yeah all it needed was a good beating, nothing else holds it on.
Also its BRAKES!!! not breaks.
Also its BRAKES!!! not breaks.
Last edited:
Yeah all it needed was a good beating, nothing else holds it on.
Also its BRAKES!!! not breaks.
why do the back lines need bleeding though? surely there shouldnt have bin any air get into the back lines? and plus the front brakes do most of the work and im sure i bled them suckers right through :/
its not that hard to do them mate do the job right!
start with the back wheel passanger side then driver side then front passanger side and last front driver side.
did you get the disc off mate yoiu really should put new pads on as they will have worn the way the discs have so will fuck your new discs up:shoot:
Dont take off nut in the middle!!!!!
It doesnt need to come off!!!!
Yeah no need for that to come off. Think its a deep-reach 32mm anyway. I broke two breaker bars trying to undo mine to change my wheel bearing! Yeah, that's right, broke them...sheered in half! Someone had over-torqued it! And I went at it with a breaker bar with scaffolding pole on it! Haha lol