is there much to notching the block when fitting scat rods and what kinda tool would ya use??thanks
P poke Member + Jun 19, 2012 #1 is there much to notching the block when fitting scat rods and what kinda tool would ya use??thanks
madman Member + Jun 19, 2012 #2 If yo want to do it yourself and save a few pounds a file will do the job easy just turn the crank over with the rods attached and file away until you have the proper clearance
If yo want to do it yourself and save a few pounds a file will do the job easy just turn the crank over with the rods attached and file away until you have the proper clearance
P poke Member + Jun 19, 2012 #3 i tryed with a file but it looked like it was taking off nothing.....does there need to be a lot taken off???
i tryed with a file but it looked like it was taking off nothing.....does there need to be a lot taken off???
A AdamB Member + Jun 19, 2012 #4 A couple of mm should do. To speed things up you could use a die grinder or another roatary tool with an abrassive end.
A couple of mm should do. To speed things up you could use a die grinder or another roatary tool with an abrassive end.
