Removing ABS (glanza)

[kingyglanza]

Hi ya,
Just a quick question.
Has anyone removed the ABS system from a Glanza?
Is it an easy job? What parts are needed?
Thanks in advance.

 

[dac69er]

why do you want to do this?

you can just remove the fuse that controls it and then it will act as though you have no abs.

 

[kingyglanza]

Because ever since i have fitted uprated disks, pads and brake lines its become very intrusive and annoying.
I will be doing lots of track days this year aswell so i want it gone.
I have the engine dropped out at the moment while im fitting my LSD so will be no problem removing ABS, just need to know how and what parts i need.

 

[dac69er]

it is not an easy job. if you dont want to worry about the electrical side of things you just need the brake line setup from a starlet with no abs, or you can buy a length of brake piping and run it yourself.

personally i would just disconnect the fuse from the abs pump. that way it wont have any effect and you can always put it back easily if need be

 

[kingyglanza]

Ok buddy i will give that a go and see how i get on. Thanks.

 

[Diver003]

A.b.s Problem

a month ago a bought a toyota glanza v model 1996 few days later we notice that abs is not working but when we bridge it from a wire that goes in the relay it works properly. so we began many tests on it checked sensors the looked good no dirt on shafts too,changed relay still not working,pump motor look good if was not could not work when it was bridged,abs light in dash works normal no electrian can find the fault! I'm getting crazy last chance is to change abs icu if still problem persists i have to live with may new glanza without abs. can someone help me pls?? i really wish to make slove the problem.tanks