running over .8 boost

im currently running .9 boost on a ct9 with an air filter on efi pipe fmic catback decat and stainless mani wondering would this do damage to my engine??? would it be runnning lean?? wat kind of power would i be pushing?
 

clarkytrd

Member +
your gettin boost creep, or your boost gauge aint reading properly cause you should be hitting fuel cut.

yes it will do damage so make sure your boost gauge is reading right for a start.
 

222BHP ROCKET

Fresh Recruit
I have a 222bhp glanza runnin at .8bar safly with similar mods to urs but i av a hks fcd.... der will soon be back pressure on ur engine turn down ur boost
 

grum-glanza

Member +
rite if you wanna run over .8 bar safely you relly need a fuel cut defender (fcd) and a fuel presseur reglator and a good boost controller not a manual one the first stuff i put into my car was the fcd, fuel presseur regaltor and a apexi avcr boost controller running 1.2 bar on a ct9 with standard manifold and it was fairly quick oh ya you'll need iridium plugs not sure what heat range but heat range 7 shud work for those mods
 

glanza2281

Member +
you dont need a fuel pressure regulator now...you just have to make sure the car never runs lean....how can you be sure that you are hitting fuel cut? EMU can be a good choice for you.
 

peter88

Member +
rite if you wanna run over .8 bar safely you relly need a fuel cut defender (fcd) and a fuel presseur reglator and a good boost controller not a manual one the first stuff i put into my car was the fcd, fuel presseur regaltor and a apexi avcr boost controller running 1.2 bar on a ct9 with standard manifold and it was fairly quick oh ya you'll need iridium plugs not sure what heat range but heat range 7 shud work for those mods
i dont know lots about boost controllers but running 1.2bar on a ct9 with the standard manifold is asking for BIG trouble, the standard manis have a restrictor in them and running more boost than .8 bar will definately do a good bit of damage without an uprated one.
 
Top