Safe boost on glanza?

[loz180691]

I recently brought a glanza v and just wanted to know what boost i can run on the std ct9 turbo and std internals. Its at 0.5 bar atm

The car has a FMIC,hks actuator,front mount air filter,and a RRFPR. im also thinking of getting a emanagment setup.

What would be a ball park fig on BHP?

Any suggestions of other mods to do ETC that would be fantastic.

Thanks,

 

[markostarletturbo]

1bar on standard internals with supporting mods you can achieve around 190bhp with standard ct9 and supporting mods

 

[www.glanza.co.uk]

Don't worry about what power figures you get, just make sure it runs safe. Doing your homework on what mods support what boost is fun, and will give you a better understanding of the car.

 

[loz180691]

when you say supporting mods what do you mean? I just want it abit faster witout the cost of massive things i will get to them at some point just want to get the best from my car atm

 

[mark1991]

If you boost past 0.8bar you will need RRFPR (which you have) and you could go down the fuel cut deffended and rrfpr route but its a waste of time as they end up a ticking time bomb If you drive it like you stole it...they dont last.

save your pennys and do it right the first time. stand alone ecu/ piggy back ecu all the way.

 

[laskt9]

Search around. There is plenty of info out there. Remember the rods are smaller than gt rods

Sent from my SGH-I927 using Tapatalk 2

 

[loz180691]

I'm going for emanage blue hks actuator and updated fuel pump running 1 bar on std ct9 is this safe to do

Tuning developments are doing it aswell