Scat conrod notching

[reyft]

Today İ will open engine, actually i don't have long time to do it, i thought without take out engine (crank) make notching with small Dremel carefully and cover over journals properly with some think cloth ect. When finish notching i'll clean it brush down.

Someone done before this? any idea?

Usually How many millimeter need Notching?

Thanks..

 

[Skalabala]

Yes sure it will work. But the cleaning part might be a problem.
Also pull of a few main caps to do some inspection.
make sure you smooth the burs with P1000 sand paper on the sleeve where the piston will touch.

 

[yaristurbo]

It will probally chew through dremel bits, and don't advise this with out a full clean of the engine, that shit gets every where

 

[pockrockgtti]

take it out, strip it down and do it properly!

 

[Jammy3990]

In the middle of doing it myself using a dremel aslong as your carefull and will need a full ckean after

 

[reyft]

It will probally chew through dremel bits, and don't advise this with out a full clean of the engine, that shit gets every where

((;